Asrock G31M-VS2 Instant Boot Driver
Boot Settings Configuration. ASRock G31M-VS2 Quick Installation Guide . BIOS setup menu to access ASRock Instant Flash. Unique Feature- ASRock OC Tuner - Intelligent Energy Saver - Instant Boot - ASRock Instant Flash - ASRock OC DNA - Hybrid Booster. ASROCK G31M-VS2 MICRO ATX DDR2 FSB SATA2 [art ] - CPU- LGA for Instant Boot - ASRock Instant Flash.
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* [*Free Regsitration Required]|
Asrock G31M-VS2 Instant Boot Driver
ASRock > Instant Boot
Secure load lever with load plate tab under retention tab of load lever. Before you installed the heatsink, you need to spray thermal interface material between the Asrock G31M-VS2 Instant Boot and the heatsink to improve heat dissipation. Ensure that the CPU and the heatsink are securely fastened and in good contact with each other. For proper installation, please kindly refer to the instruction manuals of your CPU fan and heatsink.
Apply thermal interface material onto center of IHS on the socket surface.
Place the heatsink onto the socket. Align fasteners with the motherboard throughholes. Rotate the fastener clockwise, then press down on fastener caps with thumb to install and lock.
Repeat with remaining fasteners. If you press down the fasteners without rotating them clockwise, the heatsink cannot be secured on the motherboard.
Connect fan header with the CPU fan connector on the Asrock G31M-VS2 Instant Boot. Secure excess cable with tie-wrap to ensure cable does not interfere with fan operation or contact other components. Otherwise, it will operate at single channel mode. If you install only one memory module or two non-identical memory modules, it is unable to activate the Dual Channel Memory Technology. Unlock a DIMM slot by pressing the retaining clips outward.
The DIMM only fits in one correct orientation. Installing an expansion cardInstalling an expansion cardInstalling an expansion cardInstalling an expansion cardInstalling an expansion card Step 1.
Before installing the expansion card, please make sure that the power supply is switched off or the power cord is unplugged. Please read the documentation of the expansion card and make necessary hardware settings for the card before you start the installation.
Asrock BIOS Updates
Remove the bracket facing the slot that you intend to use. Keep the screws for later use. Align the card connector with the slot and press firmly until the card is completely seated on the slot.
Fasten the card to the chassis with screws. The data in CMOS includes system setup information such as system password, date, time, and system setup parameters. To clear and reset the system parameters to default setup, please Asrock G31M-VS2 Instant Boot off the computer and unplug the power cord from the power supply.
G31M-VS2 Asrock Motherboard
Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
Please refer to the instruction of your IDE device vendor for the details. The current see p. Please follow the instruction in our manual and chassis manual to install your system. Enter Asrock G31M-VS2 Instant Boot Settings, and then select Chipset Configuration. Failing to do so will cause the failure to power up.
Then, the drivers compatible to your system can be auto-detected and listed on the support CD driver page. Please follow the order from up to bottom side to install those required drivers.
Therefore, the drivers you install can work properly.